Antares ATR-1a - Manual (Page 47)

47
MIDI System Exclusive Message Examples
The following examples are Scripts from Opcode’s Galaxy. They show
System Exclusive Messages which communicate with the ATR-1a.
This message will cause the ATR-1a to select Program Mode.
Put $F0 into Sys_Ex;
Put 0 1 $26 into Antares;
Put 0 into Device_Num;
Put 0 into Mode;
Put $F7 into End_Sys_Ex;
Send Sys_Ex Antares Device_Num ¬
Mode ¬
End_Sys_Ex;
This message will cause the ATR-1a to select Song Mode.
Put $F0 into Sys_Ex;
Put 0 1 $26 into Antares;
Put 0 into Device_Num;
Put 1 into Mode;
Put $F7 into End_Sys_Ex;
Send Sys_Ex Antares Device_Num ¬
Mode ¬
End_Sys_Ex;
This message sets System data in the ATR-1a.
Put $F0 into Sys_Ex;
Put 0 1 $26 into Antares;
Put $F7 into End_Sys_Ex;
Put 0 into Device_Num;
Put 4 into Mode;
Put 14 into Msg_Length;
Put 0 into MIDI_Channel;
Put 0 into MIDI_Sustain;
Put 0 into Pgm_Change;
Put 0 into MIDI_Note;
Put 0 into Pitch_Bend;
Put 0 into Mod_Wheel;
Put 0 into Foot_Switch;
Put 13 into Speed_Controller;
Put 13 into Vib_Rate_Controller;
Put 13 into Vib_Delay_Controller;