Probuilt Professional Lighting Wobblelight Super Duty User Manual
Page 5
5. Reconnect
the
Wobblelight
®
to the power source and turn the power switch on.
6.
If the Wobblelight
®
does not illuminate, turn the unit off, disconnect from the power source and take out of service (remember to allow up to 10 minutes for a metal halide
lamp to restart from hot condition).
7.
If the Wobblelight
®
illuminates, you can begin to reconnect the electrical devices plugged into the accessory outlet one at a time. Be aware of the total amp load being
placed on the accessory outlet.
8. If the circuit breaker trips again, the accessory outlet is likely being overloaded. Disconnect the
Wobblelight
®
from the power source, t
urn the power switch to
the “off” position and disconnect one or more electrical devices from the accessory outlet.
9. Reset the circuit breaker and repeat steps 5-7.
10.
If the circuit breaker continues to trip and you are certain that the accessory outlet amp rating is not being exceeded (or if nothing is connected to the
accessory plug), disconnect the
Wobblelight
®
and take it out of service.
11. Contact ProBuilt Professional Lighting customer service or your local authorized service center for repairs and/or replacement parts.
CAUTION: The Wobblelight
®
circuit breaker is an important safety feature.
Do not remove, alter or disable the Wobblelight
®
circuit breaker.
Do not operate Wobblelight
®
without the circuit breaker in place.
Do not use tape or similar means to try holding the breaker in a permanent “reset” position. The breaker will still trip.
Any improper use or modification of the circuit breaker will void the warranty and may result in
fire, electric shock, damage to property or injury to persons.
GFCI
If your Wobblelight
®
Super Duty is equipped with an in-line factory-installed Ground Fault Circuit Interruptor (GFCI) please refer to the enclosed
manufacturer’s instructions for safe and proper operation.
MECHANICAL OPERATION
Super Duty Wobblelight
®
is equipped with a theft-deterrent locking shackle. DO NOT use to lift, hoist or suspend Wobblelight
®
above people or work areas.
DO NOT pull or drag the Super Duty Wobblelight
®
by the power cord or the power receptacle.
QUESTIONS OR PROBLEMS?
Call ProBuilt Professional Lighting Customer Service and Technical Support at 877-707-0800. (Monday-Friday from 8:30 am until 5 pm Central
me.
Replacement parts are also available by contacting ProBuilt Professional Lighting customer service or your retailer.
Wobblelight
®
LIMITED WARRANTY INFORMATION
Manufacturer’s Limited Warranty
Wobblelight® products manufactured by ProBuilt Professional Lighting, LLC are warranted against defects in material and workmanship for a period of one year (Wobblelight® and
Wobblelight® Junior) or two years (Wobblelight® Super Duty) from date of purchase. ProBuilt Professional Lighting, LLC will repair or replace any defects due to faulty materials or
workmanship during the warranty period. Proof of purchase and compliance with all product use information is required. A restocking fee of 15% will be charged for all non-
defective goods. Shipment or delivery of defective products for warranty repair or replacement is the responsibility of the purchaser.
EXCLUSIONS. This warranty does not cover: