American Dynamics Tyco 8 - Manual (Page 35)

Installing IP SDU8 with a ROENDC End Cap
5-7
When power is applied, the dome checks its functionality by performing a homing routine
during which the camera pans and then either goes to the start point of the "apple peel" pattern
or if powered up once before, to the last position in memory. Once the camera stops, the
camera is online and is ready to be controlled.
Green, Orange, and Yellow LEDs will light in various patterns to indicate status. Typically, you
do not need to view these LEDs unless a failure occurs during or after the routine. See
Diagnostic LED Status Descriptions on page 7-1 for an explanation of the LED patterns.
Once the homing routine completes, affix the bubble to the dome as described in Procedure 5-2.
Attaching the Bubble to the IP SDU8 Unit
Procedure 5-2 describes how to attach the bubble assembly to the installed IP SDU8 unit.
Procedure 5-2 Attaching the Bubble to the IP SDU8 Unit
1 Remove the bubble assembly from the package and ensure the bubble is clean and free of
debris.
2 Attach the coiled lanyard from the bubble to the threaded stud on the indoor housing using the
thumb nut supplied.
Figure 5-15 Coiled lanyard before and after attachment to the housing
3 Attach the bubble assembly.
4 Align the key on the inside of the bubble assembly with the detent on the edge of the housing.
Caution
To maintain the integrity of the gasket seal between the housing flange and the trim ring, do not let the
lanyard get caught between these two pieces as you secure the bubble assembly to the housing.
Threaded Stud
Coiled Lanyard