Progressive International Electronics RLM 2 - Manual (Page 21)

RLM Systems Installation Guide Version 3.0 © November 2008
15
RLM II for ELECTRONIC DISPENSERS
Dispenser Specific Installation
RLM II for Wayne/Dresser Electronic Dispenser
Note all warnings at the beginning of installation section.
Following the instructions in RLM II General Installation, perform general installation
procedure and the preliminary test procedure using Tester/WinTester program.
Proceed with RLM II installation, referencing Diagram: RLM II Adapter Board Jumper
Selections in the preceding section — RLM II for Electronic Dispensers, General Installation.
1. Set switch position SW1 of Adapter Board for Wayne models.
2. On the Adapter Board, set switch position SW2 for current loop.
3. Set jumpers on positions H2 and H3 for Wayne models.
4. Plug adapter harness into position J2 on Adapter Board.
5. Plug the adapter cable, PIE 9000 15 3012, into the adapter port on the RLM II.
6. Locate the Wayne/Dresser distribution box and wire the other end of the adapter cable
into the unused dispenser positions in the DBox. In the event that the DBox is full, wire
in “series” with existing dispenser. The following chart shows wire color to function.
Wire Color Function
Black Loop 1 -
Red Loop 1 +
Green Loop 2 -
White Loop 2 +
7. On Wayne/Dresser DBoxes with dispensers wired into one side of the DBox board,
only one loop needs to be connected. Refer to Diagram: Wayne/Dresser DBox RLM
II Connection Example. For units with both sides of the DBox board wired, Loop 1
and Loop 2 must both be connected. Refer to Diagram: RLM II to Wayne/Dresser —
Typical Installation for installation in which 2 loops are needed.