Maple Systems STEPware-100 - Manual (Page 15)

To download a STEPware-100 project to the OIT:
1. Start STEPware-100 and open your project.
NOTE:The OIT must be in Download/Upload mode to accept a project from STEPware-100.
2. From the Transfer menu, choose Send to OIT. The STEPware 100 - Send To OIT
dialog box appears.
3. Choose the Options button. The Communication Options dialog box appears.
4. If the OIT has not been previously downloaded to, in the Download Only group box,
select the Project and OIT Operational Software option button.
5. If the OIT already contains the OIT Operational Software, in the Download Only
group box, select the Project Only option button.
6. If you want to keep unauthorized users from reading the project in the OIT, in the
Download Only group box, select the Enable? check box.
7. In the Upload & Download group box, select the COM port option button that
corresponds to the COM port the OIT is connected to.
8. Choose the Done button to return to the STEPware 100 - Send To OIT dialog box.
9. Choose the OK button to start the transfer.
When the transfer is complete, the OIT restarts. The OIT is now ready to communicate
with the host controller.
12 STEP1 Protocol Operation Manual
1010-0096, Rev. 04