Maple Systems STEPware-100 - Manual (Page 4)

CHAPTER 1
Getting Started
The Getting Started chapter walks you through all the steps required to setup your OIT:
• What You Will Need
• Installing STEPware-100
• STEPware-100 Tutorial
• Downloading a STEPware-100 Project to Your OIT
• Verifying Your OIT is Operational
• Connecting Your OIT to the Host Controller
What You Will Need
The table, below, lists the items you will need to configure and operate your OIT.
OIT3160A/
OIT4160A
OIT3100 and
OIT4100
Series, except
3160A/4160A
MAP460/
OIT3600
All Other
Models
Configuration Software STEPware-100 STEPware-100 STEPware-100 STEPware-100
Configuration Cable
(OIT to PC)
7431-0049 7431-0096 7431-0048 7431-0049
Personal Computer 1 User Provided User Provided User Provided User Provided
Power Cable 6030-0009 6030-0009 Not Required 7431-0050A
1/2 Amp, 24 VDC
Power Supply 2
User Provided User Provided User Provided User Provided
Host Controller User Provided User Provided User Provided User Provided
Communication Cable
(OIT to Host Controller) User Provided User Provided
User Provided User Provided
1 Computer requirements include at least a 486SX/33MHz PC, 4MB RAM, 4MB
available hard disk space, VGA video controller, Microsoft Windows 3.1, and one
available RS-232 serial port.
2 The MAP340, OIT4400, and OIT4450 require a fast start power supply.
Installing STEPware-100
To install STEPware-100:
1. Start Windows. If any applications are running, close them before continuing.
2. Place the STEPware-100 Setup Disk into your 3.5-inch floppy drive.
3. Windows 3.x: In Program Manager, from the File menu, choose Run.
Windows95 and NT4.0: From the Task Bar, choose Start, then Run.
Getting Started 1
1010-0096, Rev. 04