Maple Systems MAP460D - Manual (Page 14)

3. OIT Configuration Wiring
The MAP460D must be configured for a particular protocol before use. The
MAPware-100 or STEPware-100 software (used on a computer with Windows 3.1
or later) is used for OIT configuration. For detailed instructions on installing and
using the software, please consult your software documentation.
3.1. Connect MAP460D to PC for Configuration
To configure the MAP460D using Maple Systems’ configuration software, remove
the operating cable from the terminal block pins and connect the OIT to the
computer using an RS-232 serial communications cable (P/N 7431-0048,
purchased separately from Maple Systems). The configuration cable should be
connected to the proper COM port on your computer, then attached to the terminal
block pins on the MAP460D. See Figure 11 below for pin assignments.
14 MAP460D
1010-0093, REV 03
Printer
Com2
Back
of
OIT
7431-0048
Com1
- +
OIT
GND
PC
OIT Power Supply
Maple Systems
OIT to PC cable
(If mouse is using
Com 1, use Com2)
Figure 11 MAP460D to PC RS-232 Communication
9S
10
COM
RXD
TXD
+24V
3
9
2
1
TB1
OIT
PC
Shield
+24V
GND
Power
Supply
CTS
DSR
RTS
DCD
DTR
GND
TXD
RXD
8
7
6
4
1
3
2
5
Red
Black
Black
Red
Blk
Green
White