Proface APL3000B - Node Box PC - Manual (Page 15)

15
face of the holder, twist the USB Cable
Clamp’s band around the USB cable, pull
the band in the direction of the arrow, and
then fasten the band using the clamp.
• Be sure the clamp is securely holding the
USB cable’s plug and collar.
• Be sure the clamp is positioned as shown
in the following image, with the clamp
pointing upwards - not to the side. This is
to keep the clamp from interfering with
nearby connectors and their cables.
„ Removing the USB Cable Clamp
(1) To remove the clamp from the USB cables,
push down on the clamp strap’s clip to
release it while pulling up on the clamp.
Installation prerequisites for
standards
For the detailed certification's information,
refer to the Pro-face Home page.
<Cautions>
Be aware of the following items when
building the PL into an end-use product:
• The PL unit’s rear face is not approved as
an enclosure. When building the PL unit
into an end-use product, be sure to use an
enclosure that satisfies standards as the
end-use product’s overall enclosure.
• The PL unit must be used indoors only.
• Install and operate the PL with its front
panel facing outwards.
• If the PL is mounted so as to cool itself
naturally, be sure to install it in a vertical
panel. Also, according to the installation
requirements, create space around the rear
face of the PL unit. The temperature must
be checked on the final product in which
the PL unit is installed.
• For use on a flat surface of a Type 4X
(Indoor Use Only) and/or Type 12 Enclo-
sure.
• Type 4X (Indoor Use Only) and/or 12
Enclosure, when the hatch for Front USB
Port is secured by screw.
Type 1 Enclosure, when the hatch for Front
USB Port is open.For use on a flat surface
of a Type 1 Enclosure.
• Front module (3620003-03) must be used
with control box (3582302-01 / 3582302-
11).
<Hazardous Locations -
Compliance and Handling Cautions>
• Suitable for use in Class I, Division 2,
Groups A, B, C, and D Hazardous Loca-
tions only.
• WARNING: Explosion hazard - substitu-
tion of components may impair suitability
for Class I, Division 2.
• WARNING: Explosion hazard - do not dis-
connect equipment while the circuit is live
or unless the area is known to be free of
ignitable concentrations.
• WARNING: Explosion hazard - when
using the PL with the AC type power sup-
ply, be sure to attach the Power Switch
Cover.
<Control Drawing of USB I/F on PL's
Front Module>
The information below concerns the use of
the USB I/F located on the PL unit's front
modules used in Class I, Division 2 Groups
A, B, C, and D hazardous locations (from
Doc No. 3501429).