Yokogawa GD40 Gas Density Detector - Manual (Page 93)

<6. CALORIE / PARAMETER SETTING>
6-4
IM 11T3E1-01E
6.1.3 Setting Parameters at Setting Level
Press the [*] key and enter the password (XXX) to gain access to this level (see Figure 6.5 for key
operation).
Table 6.3 Setting Parameters at Setting Level
Mode/Setting parameter Display
Data to be Set
(or Conditions)
Remarks
Analog output setting
Output 1
Set a parameter to be output
Set the zero and span points
Physical density
Compensated density
Calorific value
Output 2 (same as output 1)
*RANGE
*OUT1
*DENS
*C_DNS
*CALRY
*TEMP
*PRESS
*Z_DNS,
*S_DNS
*Z_CP.D,
*S_CP.D
*Z_CAL,
*S_CAL
*OUT2
Physical density
Compensated density
Calorific value
Gas temperature
Gas pressure
00.0000 to 60.0000 kg/m 3
0.00000 to 4.00000 lb/ft 3
0.0000 to 6.0000 kg/m 3
0.00000 to 0.40000 lb/ft 3
000.000 to 133.000 MJ/m 3
0.0000 to 3.5000 kBTU/ft 3
See Figure 6.5 for key operation.
No setting is required if the parameter is
temperature or pressure.
Setting calibration data
Zero-point calorific value
Zero-point density
Span-point calorific value
Span-point density
Output hold value during calibra-
tion
Setting of preset value
(Only if the preceding parameter
is set to 2 (preset value))
*CAL.DT
*Z_CAL
*Z_DNS
*S_CAL
*S_DNS
*C_HLD
*PR.SET
000.000 to 133.000 MJ/m 3
0.0000 to 6.0000 kg/m 3
0.00000 to 0.40000 lb/ft 3
000.000 to 133.000 MJ/m 3
0.0000 to 3.5000 kBTU/ft 3
0.0000 to 6.0000 kg/m 3
0.00000 to 0.40000 lb/ft 3
· Disable: 0
· Enable (value
immediately before) : 1
· Enable (preset value) : 2
-10.0 to 110.0
See Figure 9.2 for key operation.
Alarm-point setting
Select a parameter for which an
alarm is set
Physical density
Compensated density
Calorific value
Set the high/low limits.
Physical density
Compensated density
Calorific value
*ALARM
*DENS
*C_DNS
*CALRY
*L_DNS,
*H_DNS
*L_CP.D,
*H_CP.D
*L_CAL,
*H_CAL
00.0000 to 60.0000 kg/m 3
0.0000 to 6.0000 kg/m 3
000.000 to 133.000 MJ/m 3
See Figure 6.6 for key operation.