Yokogawa DAQWORX - Manual (Page 21)

2-10 IM WX1-07E
Decimal point: Set the offsetting decimal place for writing to registers. Select 0, 1, 2, 3, 4,
or 5.
Span minimum/maximum :
Setting range: –1E9 to 1E9
If the value requested by AddObserver is outside of the span range, it is
not output.
Units: Specify using six alphanumeric characters or fewer.
Note
Registers 41280 (UTM, USM, UPM) and 41281 (SMP) of the UT520, UT550, UT551, UT750,
US1000, UP550, and UP750 cannot be written using the Modbus/RTU, Modbus/TCP protocol.
Please make note of this.
Input link: Displays and selects the tag for intput that is linked to the output tag.
Displayed in the format xx:tag name where xx is the input tag name.
When you click an input select button, the tag selection dialog box is
displayed.
Input select button
Click here to display the Tag Selection dialog box.
Links are not set
Click here (blue) to apply the edited register numbers
in the input tag to the output tag
Display the tag that links are not set of registered tags
of the input tab page
Output value: Specifies an output value for the output test.
Range: –1E9 to 1E9
Loaded value: The output register value is displayed after the output test.
If the output value is outside of the output span, “Out range” is
displayed. If a communication error occurs during output, “Com error”
is displayed.
2.2 Enterng Envronment Settngs