Ameriphone IIIP TTY - Manual (Page 18)

CHAPTER 7
(CONTINUED)
F. Clearing the Entire Memory
CHECKING DIRECTORY MEMORY
1. Hold down and press 1 to go to
the phone directory screen.
2. Hold down and press L to list
the number of free memory “spaces”
available for storing new names and
phone numbers.
3. Press while holding
down to return to normal TTY
operation.
1. Remove the paper tray cover and the print-
er compartment cover. See Figure 2 on
page 6.
2. Plug one end of the printer cable into the
PRINTER socket. See Figure 5.
3. Replace the printer compartment cover and
then the paper compartment cover so the
cable fits through the slots at the base of
the paper cover.
4. Plug the other end of the cable into your
printer.
5. Turn the printer on and make sure it's on-
line.
H. VCO ( Voice Carry Over) Calls
1. Connect the telephone to the TTY as
shown on page 6.
2. Make the call in the normal manner from
your TTY.
3. After the call is connected, lift the handset
and start talking when it is your turn. (After
seeing GA on the screen).
All DIALOGUE TTYs work with external printers
that support a standard parallel interface.
RS232 serial printers aren't compatible with
AMERIPHONE TTYs. If your
DIALOGUE TTY is
not equipped with a built-in printer, follow these
instructions to attach and use an external print-
er. External printer input impedance must be
greater than 10K OHM.
G. Using an External Printer
Figure 5 - External Printer
It is recommended that when you no longer have
any need to keep previous messages, memos,
and phone conversations, you clear them from
memory.
1. Hold down and press 5 to go to the
clear menu.
2. The first screen will read
CLEAR CONVERSATION Y/N . Press Y to
clear or N or to retain and
move to the next screen. You will see the
following screens displayed in succession:
CLEAR MESSAGES Y/N
CLEAR MEMOS Y/N
CLEAR DIRECTORY Y/N
CLEAR ALL MEMORY Y/N
Press Y to clear or N or to
retain the contents in memory. If you do
not want to clear anything, just hold down
and press
to return to normal TTY operation.
Pressing Y after
CLEAR ALL MEMORY Y/N
also resets the TTY to the factory preset
modes of operation
( see Page 7).
16