1/2 quart – MAHLE RTI ATX-2PS User Manual
Page 10
Page 9
FLUID EXCHANGE (4,8,12,16,20 QUARTS)
1.
Vehicle engine is running and the ATX-2 is connected as previously described, READY light
is illuminated.
2.
Determine vehicle transmission fluid capacity from the vehicle operator or service manual.
3.
Press the corresponding QUART button, always round up (for example if vehicle capacity is
6.5 quarts an 8 quart exchange would be selected).
4.
The change of fluid can be monitored through the ATX-2 Old-New Sight Bowls. These bowls
display the new bright red fluid leaving the ATX-2 and the dirty brown to black fluid coming
from the vehicle transmission system. The color of the used should become almost equal to
the new as the exchange ends. The liquid levels can be viewed through the Level Indicators
on either side of the ATX-2 (left side for used, right side for new).
5.
When the exchange of transmission fluid is complete the ATX-2 will automatically switch to
the bypass loop, the buzzer will sound continuously and the PROCESS COMPLETE light will
stay illuminated until the STOP button is pressed.
6.
Check transmission dip stick for level. Use +1/2, -1/2 QUART buttons as required to correct
fluid level.
-1/2 QUART
1.
Vehicle engine is running and the ATX-2 is connected as previously described, READY light
is illuminated.
2.
Check transmission dip stick. Press the -1/2 QUART button to lower the fluid level if the
transmission system is overfilled.
3.
When process is complete the buzzer will sound continuously and the PROCESS
COMPLETE light will stay illuminated until the STOP button is pressed.
4.
Check transmission dip stick for appropriate level.
+1/2 QUART
1.
Vehicle engine is running and the ATX-2 is connected as previously described, READY light
is illuminated.
2.
Check transmission dip stick. Press the +1/2 QUART button to raise the fluid level if the
transmission system is under filled.
3.
When process is complete the buzzer will sound continuously and the PROCESS
COMPLETE light will stay illuminated until the STOP button is pressed.
4.
Check transmission dip stick for appropriate level.