MAHLE RTI ATX-2PS - Manual (Page 13)

Page 12
MAINTENANCE
The ATX-2 will provide many years of reliable service if properly maintained. The following checklist
will ensure that the ATX-2 will run at peak efficiency and present an image to your customers that
your shop performs high tech transmission services.
1. Use tool tray for storage of tools and adapters only.
2. Keep the exterior surface clean. Use a mild all purpose cleaner to wipe transmission fluid and
dirt off the cabinet.
3. Do not allow the unit to sit outside in direct sunlight or inclement weather. Excessive
exposure to sunlight or moisture will cause serious damage and will void the warranty.
4. The ATX-2 is not intended for mobile use where the unit is transported to customer sites.
Excessive vibration will shorten component life, affect accuracy of performance and void the
warranty. If the ATX-2 needs to be transported by vehicle, remove all fluid, in both the new
and used tanks, prior to transport.
5. Be gentle when moving the ATX-2 around the shop. Tip the unit and ease the front casters
over any obstacles such as door jams, air hoses and floor irregularities.
6. Periodically check all internal (by lifting out the tool tray) and external hoses for leaks or
excessive wear. Any weak hoses should be replaced immediately to avoid possible injury.
7. Check the filter screens inside the old-new sight bowls often to avoid any blockage that may
occur. Clean out debris or replace the filter screen if necessary.
8. Check air pressure in rear tires periodically (should be 30 psi), add air if needed.