AMX Modero NXT-1200V User Manual
Page 30
Touch Panel Accessories
18
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
2.
Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either
side of the existing card), and gently pry the card out of the slot (FIG. 22). Repeat this process on the
opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board
connector pins.
3.
Grip the old card by its sides and then carefully pull it out of the slot.
4.
Remove the new CF memory card from it’s anti-static bag.
5.
Grip the sides of the new CF memory card and firmly insert it into the slot opening (with the arrow facing
towards the pins) until the contact pins are completely inside the flash card and it is then securely attached
to the pin sockets.
6.
To complete the upgrade process, close and resecure the panel enclosure using the procedures in the
following step.
FIG. 21
Location of the Compact Flash card and I/O plate on NXT
FIG. 22
Removing/installing a Compact Flash Memory card
I/O connector
Compact Flash card
Outer Housing
plate
Eight Housing
Screws
NXA-PCI80211G
wireless card
Card removal grooves
Insert with arrow
facing towards the pins
On-board Compact
Flash connector (with pins)
Connector opening