Nexo LS18 - Manual (Page 39)

GEO S12 HARDWARE SETUP PROCEDURE Page 39/103
 (5) Apply Loctite 243 or equivalent to the screws that attach the LS18 connector plate to
the cabinet, and reinstall the LS18 connector plates (see figure below left);
 (6) Position Geo S12 bottom counter-plates (see figure below left);
 (7) Position VNI-ANPL1 angle plates (set at 0.2°) and LSI-CPLA top counter-plates on
LS18 upper sides according to figure below right ;
 (8) Position angle plates and top counter-plates from VNI-ANPL and VNI-CPLA to
required GEO S12 inter-cabinet angle value between GEO S12 upper sides according
to figure below right;
 (9) Apply Loctite 243 or equivalent to shoulder screws from LSI-CPLA and VNI-CPLA
kits;
 (10) Screw all shoulder screws so that all plates and cabinets are tightened together;
 (11) Flip the cluster upside down to access connector plates located on the down side;
 (12) Repeat all above steps from #2 to #10;
 (13) Position the VNI-BUMPER bumper to required angle position and use the four
shoulder screws to connect it the bumper to the top cabinet;