SABINE FBX-SOLO SL820 User Manual
Page 11
11
creased activity at one of those frequencies may
cause the filter to go deeper (e.g.., deepen from -12
dB to -15 dB). Activating the Lock Fix function
prevents the Fixed filters from going deeper at their
assigned frequencies.
FIXED & DYNAMIC FILTER CONFIGURATION
The filters can be reconfigured easily from the factory
default setting (six fixed and two Dynamic) to any
combination of Fixed and Dynamic filters. For
example, the following procedure will set three filters
Fixed and five Dynamic:
1. Place the unit in Bypass mode.
2. Power down the SOLO.
3. While depressing the Reset button, power up
the unit.
4. Release the Reset button one second after the
Lock Fixed and Bypass LEDs turn on. The Filter
Indicator LEDs will now light in sequence.
5. When the third LED is lit, press the Reset button.
6. Notice that the first three LEDs flash three times
to verify that they are now the Fixed filters. Filters
which do not flash are Dynamic filters.
NOTE: The Fixed filters flash three times whenever the
FBX is powered up. Note: Resetting the number of fixed
versus dynamic filters also resets the noise gate to "off."
RESET OPTIONS
The Reset button has two functions: You can reset
all the FBX filters, or just the Dynamic filters. Press
and hold the Reset button and all filter LEDs will
begin flashing. To clear only the Dynamic filters,
press and hold the Reset button and release when
the Dynamic filter LEDs go off (after three flashes).
To clear all the filters, press and hold the Reset
button, but do not release until all the filters LEDs go
off (approximately 7 flashes). NOTE: A full reset is
recommended whenever you change speaker
or microphone positions. NOTE: Factory default
is 6 Fixed and 2 Dynamic filters, so if you reset
Dynamic filters, only those two lights will go out during
reset. A full reset also brings you into Turbo Mode.
WARNING: Do not reset all filters during the
program. This releases all the feedback you elimi-
nated during setup. Use extreme caution when
resetting the Dynamic filters, because you may need
those filters at that moment during the show.