Fbx setup instructions – SABINE FBX-SOLO SL820 User Manual
Page 14
14
FBX SETUP INSTRUCTIONS
Place the speakers and micro-
phones in the positions where they
will be used during the program.
Avoid placing microphones directly
in front of speakers. If you are
using a graphic EQ, adjust it only
for the desired tonal qualities. DO
NOT NOTCH FOR FEEDBACK.
Set the mixer master output, all
channel level faders, and the
monitors to minimum.
Turn on the SOLO. Turn on the
mixer, any signal processing
equipment, and finally the power
amp. NOTE: Compressors in the
SOLO signal path should be off
during this procedure.
Press and hold the SOLO’s Reset
button (see page 8 for more de-
tails on the reset function) until
the LEDs stop flashing to clear
out all filters set previously.
NOTE: You are now in Turbo
Mode (see page 9 for details). Be
sure the “BY” LED is green (Active
mode) to indicate the SOLO is not
in Bypass mode (red).
Turn the SOLO’s clip level adjust
to the two o’clock position.
Set the mixer master output to a
nominal level.
5
4
3
1
2
MIXER MASTER
OUTPUT, INPUT &
MONITOR LEVELS
6