SABINE FBX-SOLO SL820 - Manual (Page 7)

7
OUTPUT UNITY/LINE SWITCH
Switch to Unity (level in = level out) for standard line,
insert, or guitar level applications. In the Unity setting,
the SL820 input level equals the output level, and the
front panel knob adjusts the clip level of the input
signal to the SOLO. Switch to Line (for line level out)
if your signal needs pre-amplification. In the Line
setting the front panel knob adjusts the output gain
between 0 and +35 dB (High IN); +30 to +65 dB (Low
IN).
INPUTS & OUTPUTS
The connector labeled IN/OUT serves as both the
unit's input (tip) and output (ring) when used with a
single TRS plug. When used with a Y-cord, use the
IN/OUT as the input and the OUT as the output (for
channel insert configurations).
SM820 ONLY BACK PANEL
OUTPUT LO/HI SWITCH
In the LO setting, the SM820
has unity gain (input = out-
put); use LO for mic level. In
the HI setting, gain is ad-
justable between -15 dB
and +20 dB using the clip level adjust; use HI for line
level, or when you need to preamp the signal.
PHANTOM POWER ON/OFF SWITCH
The SM820 is set to "Phantom Power - OFF" at the
factory. If you wish to use phantom power, move the
switch to "ON." NOTE: The SM820 will not pass
phantom power from your mixer.
INPUT
The input accepts balanced XLR-3 (PIN 2 high)
plugs.
OUTPUT
Use balanced XLR-3 connectors (PIN 2 high) for
balanced mixer line inputs. NOTE: the output im-
pedance of the SM820 is unbalanced.