Stewart Audio CVA100-2 - Manual (Page 3)

3
3. The amplifier should be situated so that its location and position does not
interfere with its proper ventilation. For example, the amplifier must not
be placed on a rug, bed, sofa or similar surface that impedes airflow
across the chassis. Airflow around the unit should be unobstructed.
4. This amplifier should not be used near water, for example, near a bathtub,
in a wet basement, near a swimming pool, etc. This amplifier is intended
to be operated in a controlled indoor environment.
5. Do not place the amplifier near heat sources such as radiators, heat regis-
ters, stoves, or other appliances that produce heat.
6. The amplifier’s power supply should only be connected to 120 VAC, 60
Hz power source. Do not defeat the ground or polarization of the power
plug.
7. Route power cord and other cables so that they are not likely to be
walked on, tripped over or stressed. Pay particular attention to condition
of cords and cables at plugs and at the point where they exit the amplifi-
er. To prevent risk of fire or injury, damaged cords and cables should be
replaced immediately.
8. Clean the amplifier with a clean, damp cloth. Do not use solvents or abra-
sive cleaners. Never pour any liquid on the amplifier.
9. When left unused for a long period of time, the power cord should be
unplugged from the outlet.
10. Damaged Amplifiers requiring service should be repaired by a qualified
service technician when:
a. The power cord or AC plug has been damaged.
b. Objects have fallen, or liquid has spilled into the unit.
c.
The amplifier has been exposed to rain or other moisture.
d. The amplifier does not appear to operate normally or exhibits
a marked change in performance.
e. The amplifier has been dropped or the enclosure
damaged.
11. The user should not attempt to service the amplifier beyond that de-
scribed in the operating instructions. All other servicing should be referred
to qualified service personnel.