Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 74)

NOTE
In the SX-FI48GPP module only, the outputs of these commands are identical with one exception.
When ACL counting is shown by show statistics traffic-policy , the Packet Count is not supported
and displays "N/A".
The following example shows the output from the show access-list accounting command.
device#show access-list accounting traffic-policy g_voip
Traffic Policy - g_voip:
General Counters:
Port Region# Byte Count Packet Count
------------------ -------------------- ----------------------
7 (4/1 - 4/12) 85367040 776064
All port regions 84367040 776064
Rate Limiting Counters:
Port Region# Green Conformance Yellow Conformance Red Conformance
------------------ ------------------ ------------------ ------------------
7 (4/1 - 4/12) 329114195612139520 37533986897781760 0
All port regions 329114195612139520 37533986897781760 0
The following example shows the output on an ICX 6650 device.
device#show access-list accounting traffic-policy tf125c
Traffic Policy tf125c:
Port Regions:
---------------
0 : 1/1/1-1/1/56, 1/3/1-1/3/8, 1/2/1-1/2/4
General Counters:
Port Region# Byte Count Packet Count
---------------- -------------------- --------------------
7 (4/1 - 4/12) 85367040 776064
All port regions 84367040 776064
Rate Limiting Counters (in Packets):
Port Region# Green Conformance Yellow Conformance Red Conformance
------------ ----------------- ------------------ ------------
7 (4/1 - 4/12) 551475 224589 0
All port regions 551475 224589 0
The following example shows the output on an ICX 7750 device.
Device#show statistics traffic-policy abc
Traffic Policy tf125c:
General Counters:
Port Region# Byte Count Packet Count
---------------- -------------------- --------------------
0 235400192 1839051
All port regions 235400192 1839051
Rate Limiting Counters (in bytes):
Port Region# Green/Yellow Conformance Red Conformance
-------------- --------------------------- --------------------
0 225023872 10376320
All port regs 225023872 10376320
Syntax: show access-list accounting traffic-policy [ TPDname ]
or
Syntax: show statistics traffic-policy [ TPDname ]
The TPDname variable is the name of the traffic policy definition for which you want to display ACL
and traffic policy counters.
The following table explains the output of the show access-list accounting traffic-policy and show
statistics traffic-policy commands.
Traffic Policies
72 FastIron Ethernet Switch Traffic Management Guide
53-1003093-03