Brocade FastIron Ethernet Switch Traffic Management Guide - Manual (Page 96)

The following example displays information for all the scheduler profiles configured in the system:
Device(config)# show qos scheduler-profile all
User Scheduler Profile: user1 Scheduling Option: Weighted round-robin
Ports attached: 1/1/1
Per Queue details: Bandwidth%
Traffic Class 0 1%
Traffic Class 1 1%
Traffic Class 2 10%
Traffic Class 3 10%
Traffic Class 4 10%
Traffic Class 5 10%
Traffic Class 6 20%
Traffic Class 7 38%
User Scheduler Profile: user2 Scheduling Option: Strict scheduling
Ports attached: --
User Scheduler Profile: user3 Scheduling Option: Mixed-SP-WRR
Ports attached: --
Per Queue details: Bandwidth%
Traffic Class 0 15%
Traffic Class 1 15%
Traffic Class 2 15%
Traffic Class 3 15%
Traffic Class 4 15%
Traffic Class 5 25%
Traffic Class 6 sp
Traffic Class 7 sp
User Scheduler Profile: user4 Scheduling Option: Weighted round-robin
Ports attached: --
Per Queue details: Bandwidth%
Traffic Class 0 3%
Traffic Class 1 3%
Traffic Class 2 3%
Traffic Class 3 3%
Traffic Class 4 3%
Traffic Class 5 3%
Traffic Class 6 7%
Traffic Class 7 75%
History
Release version Command history
8.0.10 This command was introduced.
store-and-forward
Syntax store-and-forward
no store-and-forward
Command Default By default, ICX 7750 runs in cut-through mode
Parameters None
Modes Global configuration mode
Usage Guidelines The no form of this command restores the default packet forwarding settings to cut-through mode.
There are two basic methodologies used for packet forwarding decisions that you can set on your
ethernet switch. These include store-and-forward and cut-through mode. ICX 7750 supports cut-through
store-and-forward
94 FastIron Ethernet Switch Traffic Management Guide
53-1003093-03