Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 149)

no multi-peri-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum and stack-unit/slotnum/
portnum to stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines Use this command only when the link is live.
The first port in a peripheral trunk or stack trunk must be an odd-numbered port, for example, 1/3/1.
Examples The following example changes the untrunked link between stack unit 1 (a backbone device) and stack
unit 3 (a peripheral device) to links between trunked ports. It creates a peripheral trunk between ports 1
and 2 on the backbone device (stack unit 1). It creates a stack trunk between ports 1 and 2 on the
peripheral device (stack unit 3).
Brocade(config-unit-1)# multi-peri-trunk 1/3/1 to 1/3/2 and 3/2/1 to 3/2/2
History
Release Command History
08.0.00a This command was introduced.
multi-stack-port
Changes both ends of a trunked link between stack trunks in a traditional or mixed stack to links
between untrunked ports.
Changes both ends of a trunked link between stack trunks in a traditional or mixed stack to links
between untrunked ports. The no form of this command removes the port configuration.
Syntax multi-stack-port stack-unit/slotnum/portnumandstack-unit/slotnum/portnum
no multi-stack-port stack-unit/slotnum/portnumandstack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines Use this command only when the trunked link is live.
multi-stack-port
FastIron Ethernet Switch Stacking Configuration Guide 147
53-1003090-02