Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 151)

no peri-port stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines This command can also be used to convert a port that is already configured as part of a peripheral trunk
on a backbone device to a peripheral port.
Any one backbone device supports a maximum of two single (untrunked) port connections to peripheral
devices. The no form of this command removes the port configuration.
Examples The following example specifies that ports 1 and 2 on a backbone device connect to a peripheral device
in a substack.
Brocade(config-unit-1)# peri-port 1/3/1
Brocade(config-unit-1)# peri-port 1/3/2
History
Release Command History
08.0.00a This command was introduced.
peri-trunk
Specifies a trunk on a backbone device that connects to a peripheral device in a substack
Syntax peri-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum
no peri-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines This command can also be used to convert a port that is already configured as a peripheral port on a
backbone device to a peripheral trunk.
The first port in a peripheral trunk must be an odd-numbered port, for example, 1/3/1.
peri-trunk
FastIron Ethernet Switch Stacking Configuration Guide 149
53-1003090-02