Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 53)

stack 2
module 1 fcx-24-port-copper-base-module
module 2 fcx-cx4-1-port-10g-module
module 3 fcx-cx4-1-port-10g-module
stack enable
stack mac 0000.0000.0011
To display the stack MAC address, enter the show chassis command.
device# show chassis
The stack unit 1 chassis info:
Power supply 1 (NA - AC - Regular) present, status ok
Power supply 2 not present
Fan 1 ok
Fan 2 ok
Exhaust Side Temperature Readings:
Current temperature : 35.5 deg-C
Warning level.......: 80.0 deg-C
Shutdown level......: 90.0 deg-C
Intake Side Temperature Readings:
Current temperature : 33.5 deg-C
Boot Prom MAC: 0000.00de.9440
Management MAC: 0000.0000.0011
The stack unit 2 chassis info:
Power supply 1 (NA - AC - Regular) present, status ok
Power supply 2 not present
Fan 1 ok
Fan 2 ok
--More--, next page: Space, next line: Return key, quit: Control-c
NOTE
For field descriptions for the show chassis command, refer to “Displaying traditional stack chassis
information.”
Removing MAC address entries
You can remove the following types of learned MAC address entries from the Brocade system MAC
address table:
• All MAC address entries
• All MAC address entries for a specified Ethernet port
• All MAC address entries for a specified VLAN
• A specified MAC address entry in all VLANs
For example, to remove entries for the MAC address 0000.0080.00d in all VLANs, enter the following
command at the Privileged EXEC level of the CLI.
device# clear mac-address 0000.0080.00d0
Syntax: clear mac-address [ mac-address | ethernet port | vlan number ]
• If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
• Use the mac-address variable to remove a specified MAC address from all VLANs. Specify the
MAC address in the following format: HHHH.HHHH.HHHH.
• Use the ethernet port parameter to remove all MAC addresses for a specified Ethernet port.
Specify the port variable in the format stack-unit/slotnum/portnum
• Use the vlan number parameter to remove all MAC addresses for a specified VLAN.
Removing MAC address entries
FastIron Ethernet Switch Stacking Configuration Guide 51
53-1003090-02