Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 15)

Universal Four-Post Rack Kit Installation Procedure 15 of 20
53-1002944-01 Rev.B
Attaching the extensions to the front of the switch
Complete the following steps to attach the extensions to the front of the switch.
1. Position the right extension along the side of the switch as shown in Figure 9 .
2. Attach the bracket using four 8-32 x 5/16-in. flathead screws.
3. Repeat step 1 and step 2 to attach the left front extension to the left side of the switch.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
FIGURE 9 Attaching the bracket extensions to the switch
1 Bracket extensions 2 Screws, 8-32 x 5/16-in., flathead Phillips