Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 8)

8 of 20 Universal Four-Post Rack Kit Installation Procedure
53-1002944-01 Rev.B
Attaching the bracket extensions to the switch
Complete the following steps to attach the bracket extensions to the switch.
1. Position the right bracket extension along the side of the switch as shown in Figure 3 .
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the extension and then into the
holes on the side of the switch. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat step 1 and step 2 to attach the left bracket extension to the left side of the switch.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
FIGURE 3 Attaching the bracket extensions to the switch
1 Bracket extensions 2 Screws, 8-32 x 5/16-in., flathead Phillips