Brocade ICX 6450-C Compact Switch Hardware Installation Guide - Manual (Page 33)

• Adequate ventilation is provided for the system. Allow 3 cm. of clearance above the device and 8
cm. of clearance on each side.
• The magnet sheet is attached to the bottom panel of the device. See Attaching the magnet sheet to
the device on page 31.
• Ensure that the device is not installed above a height of 1.1 meters. from the floor.
Note the following important installation considerations before installing the device on a metal surface
using the magnet mount:
• The strength of the magnet will vary depending on the surface it is used on.
• The magnet’s force might weaken over time. Please check the strength of the magnet regularly, for
about one year. Please move the device up and down and confirm strength.
When adequate ventilation is provided and the magnet is attached to the device, you can securely
mount the device in the following locations:
• A metal wall or metal surface. See Mounting the device on a metal surface or metal wall on page
32.
• Underneath a metal desktop. See Mounting the device under a metal desk on page 34.
Attaching the magnet sheet to the device
Before mounting the device to a metal surface, place the logo side of the magnet sheet (displaying the
Brocade logo) squarely against the bottom panel of the device to attach the device to the magnet sheet,
as shown in the figure below.
CAUTION
The magnet sheet can only be placed against the bottom panel of the device. Do not attempt to
attach the magnet sheet to any other panels on the device.
Attaching the magnet sheet to the device
Brocade ICX 6450-C Compact Switch Hardware Installation Guide 31
53-1003081-01