Brocade Mobility RFS9510 Controller Installation Guide - Manual (Page 14)

10 Brocade Mobility RFS9510 Controller Installation Guide
53-1002918-01
Hardware installation
3
Installing the Mobility RFS9510 Controller
1. Complete the instructions supplied with the rail kit to mount the Mobility RFS9510 Controller in
an equipment rack.
2. Connect the power cords for both power supplies.
3. Connect the Ethernet cables, and connect the controller to the network.
4. Connect a standard VGA monitor to the video port on the back of the controller.
5. Connect a keyboard and mouse to the USB ports on the back of the controller.
6. Gently press the power button to apply power to the controller.
7. When the WING login prompt is displayed, press enter to activate the console window.
8. In the console window, login using username admin and password admin123.
9. When prompted, enter a new password, then enter it again to confirm it.
NOTE
Use of the serial port for the Mobility RFS9510 Controller is not supported.