Brocade Mobility RFS7000 Controller Installation Guide - Manual (Page 15)

Brocade Mobility RFS7000 Controller Installation Guide 7
53-1001574-03
Chapter
3
LED Codes
In this chapter
• System status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
• RJ-45 Gigabit Ethernet LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
• SFP Gigabit Ethernet LEDs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
• Out of band management port LEDs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
The Mobility RFS7000 Controller has four vertically-stacked LEDs on its front panel.
Each of the switch’s Gigabit Ethernet ports have two status LEDs. These LEDs
display two colors (green & amber), and three lit states (solid, blinking, and off). The
following tables decode the combinations of LED colors and states for the System
Status LEDs and the Gigabit Ethernet LEDs.
System status LEDs
System Status 1
Fan status
Temperature status
System Status 2