Burcam F80210 ELECTRONIC HOUSE FANAIR - Manual (Page 2)

2
INSTALLATION GUIDE FOR THE BURCAM’S Fan Air
MODEL F80210
SAFETY INSTRUCTIONS:
This fine product that you have just purchased is designed from the latest in material
and workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL CODES TO ENSURE
YOU COMPLY WITH THE LOCAL REGULATIONS. THESE CODES
HAVE BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE
YOU COMPLY WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM
THE HOME ELECTRICAL DISTRIBUTION PANEL PROPERLY
PROTECTED WITH A FUSE OR A CIRCUIT BREAKER. A GROUND
FAULT CIRCUIT IS MANDATORY. CONSULT A LICENSED
ELECTRICIAN FOR ALL WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS
SHOULD NEVER BE REMOVED. THEY ARE SUPPLIED AND
DESIGNED FOR YOUR PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE
OR PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY
UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE
POWER PLUG FROM THE RECEPTACLE.
The necessary tools for the installation are: One electric reciprocal saw
or one 160 mm (6¼” diameter) hole saw and one 6mm (1/4”) diameter
drill bit with one electric drill. It is suggested to used white caulking as
whether seal around your outside vent. A Robertson or Phillip
screwdriver will also be necessary.
Preparation
A
B
C
D