Burcam F80210 ELECTRONIC HOUSE FANAIR - Manual (Page 4)

4
INSTALLATION GUIDE FOR THE BURCAM’S Fan Air
MODEL F80210
From the center of the 1/4'' (6mm) hole, calculate
a distance of 7 5/8'' (194mm) below same and
make a horizontal line to mark the position of the
top of the wall support.
From the exterior of the building, using the
pre-drilled 1/4'' hole as a pilot, drill a 6 1/4'' (160mm)
hole to allow the passage of the evacuation pipe.
Using the provided screws
and anchors, fix the long
support to the wall. Then,
under same, fix the short
wall support leaving
1/8'' (3mm) in between
them.
Still using the provided
screws, fix the suction
piece to the wall support.
Then screw the mid section
with 2 screws.
STEP 2
STEP 3
STEP 4
STEP 5
194mm
7 5/8”
4
5
2