LT Security LTD911M6KIT2 - Manual (Page 11)

User Manual
5.10 Motion Detector Setup
This section allows you to set up motion detection options for each camera.
MOTION DETECTOR SETUP:
ON/OFF: Enable or disable motion detection
recording.
10
Press “Stop” button to disable all areas, press “All” button to enable all areas
5.11 Hard Drive Setup
This section will display the current hard drive status and usage options
MOTION DETECTOR SETUP
CH1 ON LEVEL1 AREA
CH2 ON LEVEL2 AREA
CH3 ON LEVEL2 AREA
CH4 ON LEVEL2 AREA
CH5 ON LEVEL2 AREA
CH6 ON LEVEL2 AREA
CH7 ON LEVEL2 AREA
CH8 ON LEVEL2 AREA
CH9 ON LEVEL2 AREA
( )MOVE (SEL)SELECT (MENU)EXIT
HARD DRIVE SETUP
OVERWRITE ENABLED [ ON ]
ST3160215A
MASTER HDD SIZE 160133MB
MASTER HDD USED 124931MB 78%
MASTER HDD FORMAT
SLAVE HDD SIZE N/A
SLAVE HDD USED N/A
SLAVE HDD FORMAT
( )MOVE (SEL)SELECT (MENU)EXIT
LEVEL: Sensitivity for motion detection.
There are 3 levels sensitivity:
Level 1-low,
level 3- highest
AREA: Select detectable area on the screen.
Area Selection:
Press [▲, ▼, ◄◄ or ►►] button to
select a block, and press [SEL] button to set
the block to detect motion. The area is
detectable when it is clear, the area is not
detectable when it is covert by shadow.
OVERWRITE ENABLED:
ON: Overwrite oldest video when hard drive
is full.
OFF: Stop recording when hard drive is full.
HDD SIZE: Indicates the total
capacity of the hard drive installed in the DVR.
HDD USED: Indicates the space used in the hard disk drive for recording and the
percent used.