LumaSense Technologies IGA 320/23-LO - Manual (Page 34)

IGA 320/23-LO Operating Manual Data format UPP (Universal Pyrometer Protocol) 34
Description Command Parameters
External clearing: AAlx Clearing the max. value storage (only with lz = 7, external)
Analog output: AAasX X = 0 or 1 0 = 0 … 20 mA;1 = 4 … 20 mA
Reading basic
temperature
range: AAmb Output: XXXXYYYY (hex 8-digit, °C or °F)
XXXX = beginning of temp. range
YYYY = end of temp. range
Reading
temperature sub
range: AAme Output: XXXXYYYY (hex 8-digit, °C or °F)
XXXX = beginning of temp. range (°C or °F)
YYYY = end of temp. range (°C or °F)
Setting of
temperature sub
range:
AAm1XXXXYYYY XXXX (hex 4-digit) beginning of temp. range
YYYY (hex 4-digit) end of temp. range
Address: AAgaXX XX = (00 ... 97)
00 ... 97 = regular device addresses
99 = Global address with response
98 = Global address without response
(only setting commands!)
Baud rate: AAbrX X=0...5 (decimal)
0 = 1200 Baud 2 = 4800 Baud 4 = 19200 Baud
1 = 2400 Baud 3 = 9600 Baud 5 = 38400 Baud
Temp. display
°C / °F AAfhX Output: X = 0: display in °C; X = 1: display in °F
Wait time: AAtwXX XX = 00 ... 99 (decimal, in bit time of the current baud
rate)
Internal
temperature:
AAgt Output: XXX (dec. 000 ... 099°C, 032 ... 210°F)
Max. internal
temperature: AAtm Output: XXX (dec. 000 ... 099, always in °C)
Limit switch SP1: AAslXXXX XXXX = set Limit switch, hex 4-digit, °C or °F
Mode
Limit switch SP1: AAt1X X = 0 Limit switch Off
X = 1 Limit switch close above
X = 2 Limit switch close below
Hysteresis
Limit switch SP1: AAhlXX XX = set hysteresis, hex 2-digit, °C or °F
Error status: AAfs Output: XX;
XX=00…FF (00 = no error)
(01…FF: error code for LumaSense service)
LED aiming light: AAlaX X = 0 switch off aiming light
X = 1 switch on aiming light
LED aiming light
at Power-on AAlpX X = 0 aiming light off at Power-on
X = 1 aiming light on at Power-on
Reading
parameters: AApa Output 11-digit, decimal:
Digit 1 und 2 (10...99 or 00): Emissivity
Digit 3 (0 ... 6): Exposure time
Digit 4 (0 ... 8): Clear time max. / min. value storage
Digit 5 (0 ... 1): Analog output
Digit 6 und 7: (00 ... 98): Internal temperature
Digit 8 und 9 (00 ... 97): Address
Digit 10 (0 ... 6 or 8): Baud rate
Digit 11 always 0
Device type: AAna Output: “IGA 320/23-LO” (16 ASCII-characters)
Serial number: AAsn Output: XXXXX (dec. 5-digit)