LumaSense Technologies INNOVA 1309 - Manual (Page 5)

Safety Considerations
________________________________________________________________________
________________________________________________________________________
BE1285-15 1309 Multipoint Sampler LumaSense Technologies A/S
Page 5 of 42
Copyright © 2011 LumaSense Technologies A/S
All rights reserved. No part of this publication may be reproduced or distributed in
any form or by any means without prior consent in writing from LumaSense Tech-
nologies A/S, Ballerup, Denmark.
SAFETY CONSIDERATIONS
The 1309 Multipoint Sampler complies with EN/IEC 61010-1 3 rd Ed.
(2010): Safety requirements for electrical equipment for measurement,
control and laboratory use. To ensure safe operation and retain the 1309
in safe condition, note the following:
APPLYING POWER
Before using the 1309 check that the available mains voltage match the
specified voltage and frequency for the instrument.
SAFETY SYMBOLS
The apparatus is marked with this symbol when it is important that
the user refer to the associated warning statements given in the User
Manual.
Frame or Chassis Protective earth Hazardous Voltage
WARNINGS
Before connecting or disconnecting interface cables, switch off the power
to all instruments.
If the correct function or operating safety of the 1309 is impaired, secure
the instrument against further use until the fault is repaired.
Any adjustment, maintenance or repair of the internal parts of the 1309
under power must be avoided as far as possible; if unavoidable, it must
only be done by qualified service personnel.