LumaSense Technologies INNOVA 1309 - Manual (Page 9)

Chapter 1
________________________________________________________________________
________________________________________________________________________
BE1285-15 1309 Multipoint Sampler LumaSense Technologies A/S
Page 9 of 42
1.3 Rear Panel
Fig.1.3 The rear panel of the 1309
AC Mains: A 3-pin connector accepting Power Cable for connection
to a single phase AC mains supply with protective Earth.
Mains Voltage: Connect 1309 to mains supply with 100-240 Vac, 50/60
Hz.
Outlet to Analyzer: Mounting stub for connecting the sampler system of the
1309 to the inlet of an INNOVA Gas Monitor via tubing.
See section 2.4.4 . Usable models are 1302, 3425, 3426,
1312, 1314 or 1412. In the following referred to as “Gas
Monitor”. Please contact LumaSense Technologies A/S
for available models.
Waste Air Outlet: Mounting stub for connecting the external pump to the
1309’s sampler system. See section 2.4.4 .
Interface IEEE-488: Digital interface designed in accordance with IEEE 488-
1978. The IEEE interface is identical in use to that de-
scribed in IEC 625-1; full compatibility is only a matter
of using the correct cables and connectors. For more de-
tail about the IEEE/IEC interface, refer to
Chapter 4 .
Device Address: Bank of 8 DIP switches which decide the 1309’s interface
address. See section 2.3.1 for details of how to set the
interface address.
00061-02-110311
50-60Hz 70VA
100 - 240 Vac
Fuses: T1.6AL