Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 11)

Assembly Instructions
30x40x15 Round Style Portable Building With Single Door
11
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
along the edges. If necessary, loosen up on the
tensioning pole ratchets so the cover and be adjusted
front to back. Adjust both the front and rear lace rope so
that there is an even amount of material both at the front
arch and the rear arch. Pull only tight enough to get all
excess material out of the main cover over the frame
members. Do not pull so taut that the grommets stress
the main cover flap.
After the main cover lacing is adjusted evenly across the
grommet flap, go back and re-adjust the Tensioning
Ratchets along the side edges of the Main Cover. At
this point, the main cover can be pulled taut enough to
take all excess material and wrinkles out of cover. It will
be necessary to repeat this step 2-3 weeks after unit
assembly is complete and main cover has a chance to
stretch out over the frame completely.
ASSEMBLE FRONT & REAR COVER
ON ARCH PANEL FRAMES
Step #11 – INSTALL FRONT AND REAR PANEL
ARCH FABRIC
Rear Panel Cover - With the Main Cover on the frame
and secured, next is to mount the fabric panels on the
front and rear panel walls. Start with the Rear Panel
Cover (33). The panel secures to the rear panel frame
along the perimeter of the arch with the Elastic Bungee
Cords (35) provided. The Bungee cords (35) should be
put on from the inside, so that the ball of the cord ends
up inside the frame, not between the frame member and
cover. Each grommet on the panel, as well as the
horizontal grommet flaps on the panel, should have a
Bungee cord installed. Start at the side and work
towards the to and other side, to avoid putting the weight
of the panel on the beginning bungee cords. One all
bungee cords are on, it may be necessary to re-adjust
the panel so that it is centered on the frame. At the base
of the Rear Panel Cover (33), insert the Rear Panel
Tensioning Tubes (15A) into the three packets at the
base edge of the Rear Panel Cover. Use a Fabric Band
for Tie Down Ratchet (36) to loop over the Tensioning
Tubes and secure to the Ratchet Assemblies (27).
Tighten the Ratchet Assemblies adequately to secure
the Rear Panel (33), but do not over tighten to stretch
panel.