Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 4)

Assembly Instructions
30x40x15 Round Style Portable Building With Single Door
4
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
(3C & 3D) that accommodate the Wind Brace Supports.
The first Interior Arch from the Front Arch must use
Sidewall Tube (3C), with clips for wind brace supports facing towards the end arch. Welded Wind Brace Tabs
should be on the bottom of the sidewall tube.
Each Interior Arch #3, #4, and #5 consists of:
One (1) Top Ridge Tube (1)
Two (2) Curved Roof Tubes (2)
Two (2) Sidewall Tubes (3)
SECURING BASE FLANGES
Step #2 – Secure Baseplate Flanges in Position
In order to assemble arches into a frame assembly, the
Base Flanges (5L, 5R, 6, & 7) must be secured to the
mounting surface. Refer to Figure 2 for an exact layout
of all base flanges.
Begin by determining exact location of the four (4)
corners of the building. Mark front edge and side-to-side
width of assembly on ground if not on concrete pad.
Drive alignment stakes into the ground outside of the
markings, and draw alignment strings along both ends
and sides of the building to the dimensions shown in
Figure 2. The outline of the strings will represent the
final location of the baseplate flanges. The initial
location of each Corner Base Flanges (5R & 5L) is
critical to the alignment and fit of the frame components
and cover. Locate the Left Corner Base Flange (5L) and
Right Corner Base Flange (5R) for the front corners of
the building. Secure the base flanges with either or both
the Auger style anchor (20) and the Earth style anchor
(21). Measurements shown in Figure 2 are to the center
of the upright sockets on each Base Flange.
Layout and secure all Base Plates in position as shown
in Figure 2.
Note that Sidewall Base Plates (7) and Base Plates
Front & Rear Standing Legs (6) are different and not
inter changeable. Sidewall Base Plates are used only
along each side of assembly. Standing Leg Base Plates
are positioned along the Front and Rear Arches to
secure vertical beams in each.
Figure 2 – Baseplate Location
The 40x30x15 building must be secured to a firm surface
that can receive and retain anchors firmly in position.
Both Auger Style and Earth Style anchors are included
within this assembly kit. If securing to the ground or to
blocks that might shift later, it is recommended that both
style of anchors be used to avoid base flanges moving
during or after assembly. If securing to a concrete pad,
blocks, or other hard surfaces, anchors must be field
supplied. Regardless of base material, the Base
Flanges must be secured so they cannot be moved.
Arches are tensioned at their base as they insert into the
base flange sockets.