RIKON Power Tools 20-110 - Manual (Page 12)

Do not change the setting for the out-feed table
again. This will only change if the blades
are replaced or sharpened.
12
Setting Out-feed Table to Cutter-head
Knives
WARNING
1. Unplug the Jointer from the power source.
2. Remove the blade guard by turning knob. (Figure
16) clockwise while lift up on the blade guard.
Caution: Blades are sharp! Use care while
working around the blades.
3. Open the rear door and move the motor belt until
the blade lock hole is lined up (Figure 17).
4. Insert blade lock tool. This locks the head in the
proper position for replacing the first blade.
5. Loosen table lock screw (C, Figure 15) and gib
lock screw (D, Figure 15) and raise the out-feed
table to the height of blade number one by turning
hand wheel. Counter-clockwise will cause the out-
feed table to rise. Clockwise will cause the out-
feed table to lower. Set a straight edge on the out-
feed table (Figure 18). Position of the table and
Straight edge should look like Figure 19. Use care
when handling the straight edge near the blades
so as not to damage them.
6. When the out-feed table and blade number one
are the same height, tighten gib and table lock
screws.
7. Bring the straight edge toward the left of the jointer
and confirm that blade number one is at the same
height at the left of the table as it is at the right
side of the table.
DO NOT connect machine to power source
at this time!
Cutter-head blades are extremely sharp!
Use Caution when hands are near the cutter-head!
Failure to comply may cause serious injury!
Figure 18
Figure 19
Figure 17
Figure 16