RIKON Power Tools 20-110 - Manual (Page 8)

8
Installing Bed to Stand
1. Remove rear door on cabinet.
2. Place bed assembly on top of stand, making sure the
pulleys face the rear of the cabinet. Ask a friend for
assistance with this step. (DO NOT LIFT BY TABLE
ENDS, LIFT FROM CENTER OF CASTING) (Fig. 1)
3. Line up the two holes in stand top with holes in the
bed assembly by viewing through rear access door in
stand.
4. Attach stand to bed assembly by using two 3/8" lock
bolts and washers. (See Fig. 2) Hand tighten only at
this time.
5. Line up third hole in stand with hole in bed assembly
by viewing through dust chute.
6. Install third 3/8" lock bolt and washer through dust
chute to secure bed to stand. DO NOT tighten at this
time.
Installing the Poly V-Belt
1. Place the Multi “V-Belt” on the cutter-head pulley and
through the opening in the cabinet and onto the
motor pulley. (Fig. 3)
2. If necessary loosen the motor turn-buckle to raise the
motor. Verify that the Multi “V-Belt” is positioned
properly in the center of the pulleys. (Fig. 4)
3. Check to verify the motor pulley and the cutter-head
pulley are aligned vertically, and the Multi “V-Belt” does
not touch the cabinet. To adjust the pulleys, loosen the
motor mounts and slide the motor in or out or loosen
the three 3/8” lock bolts and move the jointer top.
(Fig. 5)
4. Tighten all three lock bolts (from Assembly Section #4
& #6 above) using 14mm or 9/16” wrench.
5. Tension the Multi “V-Belt” using the motor plate turn-
buckle. A properly tensioned belt should have 1/2"
deflection when finger pressure is applied half way
between the two pulleys.
6. Re-check the Mult “V-Belt” tension after 2 hours
of use. Re-tension as needed.
Figure 1
Figure 2
Figure 4
Figure 5
CORRECT INCORRECT
Figure 3
Assembly