RIKON Power Tools 20-110 - Manual (Page 13)

13
8. If blade is higher or lower at the right of the table
than it is at the left, slightly loosen four screws
(Figure 20) by turning clockwise as viewed from
the in-feed table. To lower, turn the screw
clockwise. To raise, turn the screw counter-
clockwise. Blades are set at the proper height
when the top of the blades are1/16" above the
cutter-head. Alternately tighten four screws to
hold each blade in place.
9. Repeat this process with blades two and three.
The out-feed table and cutter-head knives are
correctly adjusted when all three blades are
parallel to the out-feed table and all three
blades are set at the same height in the cutter-
head.
If the out-feed table is set too high, a curved finished
surface results.
If the out-feed table is set too low, gouging will result at
the end of the cut.
Installing Cutter-Head Guard
1. Turn spring knob (A, Figure 21) approximately one
and one half revolutions counter-clockwise and
hold.
2. Insert guard post into hole in table. Make sure
spring engages slot in guard post.
3. Check for proper operation. Guard must return
fully to fence when released. If guard does not
return fully, remove pull guard, apply more tension
to spring knob by turning it another half turn
counter-clockwise, and re-insert guard. If guard
closes too quickly and strikes fence too hard,
release some tension on the spring.
Figure 21
Figure 20
A