RIKON Power Tools 20-110 - Manual (Page 9)

9
Figure 6
Figure 7
Figure 8
Figure 9
Installing Belt Guard
1. Place the belt guard (A, Figure 6) over the belt
opening in the stand.
2. Line up the holes in the stand with the holes in the
guard.
3. Attach the guard to the stand using two 1/4-20x1/2"
pan head screws and two 1/4" lock washers.
(B, Figure 6)
Install Fence Bed Casting
1. Use two 3/8" x 1-1/2" hex socket bolts and
washers (A, Fig. 7) to attach the fence bed casting
(B, Fig. 7) to the outfeed table bed using 13mm
socket/wrench.
2. Align top of the fence base casting flush with the
table surface and tighten.
Installing Fence to Bed
1. Remove the lock handle (A, Figure 8), flat washer,
and lock nut from the fence assembly.
2. Place the fence assembly onto the table. Be sure
key stock (B, Figure 8) on the bed lines up with
channel in the fence casting.
3. Place the flat washer and insert the lock handle
through the fence casting and the table casting.
4. Thread the special nut onto the lock handle. Make
sure the tab on the nut faces up and engages the
slot in the table casting. (Fig. 9)
A
B
A
B
A
B