Seed Hawk LOUP III & VIPER PRO 2015 - Hydraulic Drive Calibration Guide - Manual (Page 18)

SEED HAWK ® 2015 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE 13
Using the Selector Knob, adjust the Shaft Speed in
the and press the Knob or Enter to confirm selec-
tion
Set the desired Shaft Speed in the dropdown box
and select Prime
NOTE: It is important to calibrate as close to the
actual seeding rpm of the roller as possible. Refer to
the
Meter RPM charts (pg. 31-33) to get an
approximate roller rpm for the specific roller and
drill width.
Continue to next page