Seed Hawk LOUP III & VIPER PRO 2015 - Hydraulic Drive Calibration Guide User Manual
Page 30
Advertising
SEED HAWK
®
2015 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE
25
Press the
INC button to increase the PWM Out-
put (this will increase the speed of the roller)
Use the
INC and DEC buttons to achieve the de-
sired roller rpm. It is important to calibrate as close
to the actual seeding rpm of the roller. Refer to the
Meter RPM charts (pg. 31-33) to get an approx-
imate rpm the roller will be turning during seeding.
based on the specific roller and drill width.
Once the meter is primed (at least two revolutions)
select
STOP. Empty the product caught and reposi-
tion the calibration bucket under the meter
Continue to next page
Advertising