Seed Hawk LOUP III & VIPER PRO 2015 - Hydraulic Drive Calibration Guide - Manual (Page 24)

SEED HAWK ® 2015 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE 19
Calibration Procedure - Viper Pro™
ATTENTION! Exit to the Seed Hawk Viper Pro
™
Menu on the Viper monitor before powering up the
Remote Console
ATTENTION! Before a meter calibration can be
done, the implement width must be entered and the
speed calibration must be completed (see the Section
Setup Wizard and Calculating the Speed Calibration
sections in the Seed Hawk Viper Pro
™
Manual)