SoleusAir SE-PAC-08E9 - Manual (Page 11)

11
REMOTE CONTROL OPERATING INSTRUCTIONS
1) Power On and Off - If the unit is already on, press the POWER (I/O) button on the remote while
pointing the remote away from the unit. This will turn the remote on. If the unit is off, now press the
POWER (I/O) button once to manually turn the unit on. Press the Power button once more to turn the
unit off. When you press the POWER button the upper right square on the remote control LCD Dis-
play will light up. When in Air Conditioner and Auto mode, the selected temperature will appear on the
remote control display. When the unit is in Fan mode and Dehumidifier mode you will see the “- -”
icon instead of the set temperature. This shows that temperature selection is not available when the unit
is in Fan or Dehumidifier mode. When the unit is in Fan mode you will see the “F*” icon instead of the
set temperature on the control panel of the unit.
2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Auto,
Air Conditioner, Dehumidifier, and Fan only mode. The upper left square on the Remote control dis-
play will light up showing which mode is selected. In Air Conditioner mode the display will show
“COOL”, in Dehumidifier mode the display will show “DRY”, in Fan mode the display will show
“FAN”, and in Auto mode the display will show “AUTO”.
3) Fan Speed - Press the FAN speed button to cycle through high, medium, and low fan speeds. The
display on the remote control will show HIGH, MED, LOW under the “SPEED” label on the remote
control LCD display. There is an additional auto speed setting that is enabled in only cooling mode.
This speed is next setting after low when pressing the FAN speed button on the remote control. The
speeds will cycle through in this order: High, Medium, Low, Auto. Each change in speed will be asso-
ciated with a “beep” sound from the unit. The remote control will not display “AUTO” under the speed
label. Once Auto fan speed is selected the unit will beep and there will not be a fan speed displayed on
the remote control.
4) Temperature Setting - When the unit is in Air Conditioner mode you can select your desired tem-
perature. Press the +or - to select your desired temperature setting. The temperature on the LCD display
on the remote control will increase or decrease accordingly. Pressing the - and + buttons simultane-
ously will change the temperature select between °F and °C.
5) SLEEP MODE - To set Sleep mode, make sure the unit is in Air Conditioner mode. Press the SLEEP
Button on the remote control, The display on the remote control will show the “SLEEP” icon on the
remote control LCD display. When in SLEEP mode, the fan will run on low to keep fan noise at a
minimum. When in Air Conditioner mode, the temperature setting will gradually increase to 2°F above
the original set temperature for 6 hours. After 6 hours the temperature setting will return to the set tem-
perature. When in Dehumidifier mode, the temperature will not change when Sleep mode is selected.
6) CLOCK - To set the clock on the remote control, hold down either the MIN or HOUR button until the
displayed time flashes on the remote control display. Change the minutes by pressing the MIN button
and change the hours by pressing the HOUR button. Set the clock prior to programming the timer.
7) TIMER - To program the timer, first press the T-ON button. Once T-ON is pressed the auto-on timer
Fan Speed High Medium Low Auto
Remote control display HIGH MED LOW
Unit control display F3 F2 F1 FA