SoleusAir SE-PAC-08E9 - Manual (Page 12)

12
will blink in the bottom right rectangle of the remote control display. Press the MIN and HOUR but-
tons to change the clock to the desired time for the unit to automatically turn on. The minutes will in-
crease by 10 with each press of the MIN button and the hours will increase by 1 with each press of the
HOUR button. Press the T-OFF button and the remote control display will flash the desired auto-off
timer. Press the MIN and HOUR buttons to change the clock to the desired time for the unit to auto-
matically turn off. The timer is set when the auto-off time stops flashing and the words “ON” and
“OFF” are displayed next to the time.
NOTE: you can set either T-ON or T-OFF, also can set both T-ON and T-OFF . If you set both T-ON and
T-OFF simultaneously, the timer will always cycle effectively unless removed either T-ON or T-OFF.
OPERATING THE UNIT
Air Conditioner Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button.
4) Press the Mode button until the air conditioner mode icon light up on the control display.
5) Press the + or - buttons until the desired room temperature appears on the control panel
display. The temperature ranges from 61
°
F - 88
°
F (16
°
C - 31
°
C).
6) Select the desired fan speed by pressing the FAN button by using the Remote control.
NOTE: During hot days, the unit will cool the room most efficiently by setting the temperature at the low-
est setting and the fan speed on high. Reducing the length of the exhaust duct, insulating the ex-
haust hose and window kit, and keeping direct sunlight to a minimum will also improve the cool-
ing efficiency.
NOTE: When the unit is running on cooling mode, the exhaust hose is required and must be
vented outside using the supplied window kit.
Dehumidifier Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER Button.
4) Press the MODE button until the dehumidifier mode icon light up on the control panel display.
NOTE: The unit operates at low fan speed during dehumidifier mode. The unit cools room slightly dur-
ing the dehumidification. Keep the windows and doors closed to aid the effectiveness of the unit in
removing the moisture from the room.
NOTE: When the unit is running on dehumidifier mode, the exhaust hose is required and must be
vented outside using the supplied window kit.
NOTE: The unit will not perform in dehumidifier mode when the room temperature is lower than 61
°
F .
Fan Mode
1) Plug the Power Cord into an electrical outlet.
2) Turn on the unit by pressing the POWER button on the control panel.