Spectra Precision Survey Pro v5.4 - Manual (Page 92)

82
Staking Points
With GNSS
• Go to the Stakeout menu and tap Stake Points
• Select the point to be staked using one of the two possible methods, as well
as the criterion allowing Survey Pro to prompt the next point to be staked
(see Selecting Points to Be Staked, “Next Point” Scenario on page 76)
• Set the rover antenna height.
• Tap Stake. This opens the screen that will guide you to the point. Survey Pro
offers two different navigation modes to help you walk to the design point.
NOTE: In the example above, the direction to follow is provided as Go North / Go East
instructions. Survey Pro can instead provide Azimuth / Distance to the point if it’s
more convenient for you. Go to Job > Settings > Stakeout tab to change the setting of
the Display Directions As field. Point tolerance (different from acceptance criteria)
can also be set on this tab.
Tap on the / button to select one of these modes:
– : The top of the screen will always show the selected reference point
or azimuth you select through the Ref... button ([1]).
– : The top of the screen will always show the direction in which you
are walking ([2]). A large red arrow will appear as you walk. The North
(N) and South (S) directions will be shown as well. You can also define
a reference point or azimuth using the
Ref... button. The resulting
direction will appear as a blue line starting from your current position.
• Walk toward the design point following the instructions on the screen (see
table below).
[1] [2]