Spectra Precision Survey Pro CE v3.80 Ranger GPS Reference Manual - Manual (Page 16)

GPS Reference Manual
16
Radio Settings Screen
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV %DVH 5DGLR &RQILJXUH 0RGHP
-or-
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV 5RYHU 5DGLR &RQILJXUH 0RGHP
The Radio Settings screen is used to configure settings of the base or
rover radio mode. All settings available are described below.
However, not all radios support all of the described settings, so if you
do not see one of these fields, it is because the radio type does not
support it.
Pac Crest Radio Settings screen. Trimble Radio Settings screen.
Baud : displays the baud rate the radio is currently set to.
Parity : displays the parity the radio is currently set to.
Channel : is where you select the channel the radio will use to
communicate with the other radio.
Sensitivity : is where you select the sensitivity of the radio.
Mode : is where you select the base radio mode of the radio.
6HW : sends commands to the radio firmware to configure the settings
selected on this screen.
Note: some settings on the radio cannot be modified with Survey Pro.
To fully program the radio modems, you need to PC software that
should be supplied with the radio.