Spectra Precision Survey Pro CE v3.80 Ranger GPS Reference Manual - Manual (Page 30)

GPS Reference Manual
30
6HWXS +5 : opens the Rover Receiver Antenna screen, which is
identical to the Base Receiver Antenna screen discussed on Page R-27
where the details of the rover antenna are defined.
3URMHFWLRQ : opens the Projection screen (Page R-37).
9LHZ 3RLQW : opens the View Coordinates File screen, where the
project points can be examined.
3RVW 3URFHVV : opens the Receiver Session screen, described on Page
R-73.
&KHFN : opens the Check Control Point screen, where the local
coordinate computed from the measurement is compared to the local
coordinates known value.
&RQWURO : when available, opens the Occupy Control Point screen,
where geodetic coordinates are measured to a point with local
coordinates and stored in the job file.
Manual Entry GPS
6XUYH\ &RQWURO 3RLQWV 
The Manual GPS screen allows you to manually enter geodetic
coordinates from the Control Points and Check Points routines. You
must have your
Brand set to Manual Mode and your Model set to
Manual Entry on the Job/Settings screen to open the manual entry
screen.
Local Coordinates: is the local plane
coordinate of the selected control or check
point
Latitude : is where you enter the WGS84
latitude of the point.
Longitude : is where you enter the WGS84
longitude of the point.
Ellipse Height : is where you enter the WGS84
ellipsoid height of the point.
$FFHSW : adds the WGS84 geodetic coordinates to the plane point
record and flags this point as a GPS control point.