Start recording in receiver, Data collection – Spectra Precision Survey Pro v3.80 Recon GPS User Manual User Manual
Page 76
GPS User’s Manual
72
Start Recording in Receiver
1.
With the
GPS Mode
set to
Post Process
, go to the Survey menu.
2.
Choose Start Static Rx. if you want to configure a receiver to
record raw data at a stationary setup. Choose Start Stop/Go Rx.
if you want to configure a receiver to do stop and go data
collection.
3.
Tap
&KDQJH 6HWWLQJV to select a new
Rec Interval
or
Threshold
values.
4.
Tap
6HWXS +5 to select an antenna type and enter the slant or
vertical measurement.
5.
Tap
6WDUW 5HFRUGLQJ to create a new file in the receiver memory
and begin logging GPS raw data.
6.
Tap
6WRS 5HFRUGLQJ to close the file and stop logging GPS raw
data.
Note:
6WDUW 5HFRUGLQJ only begins the logging of raw data to the
receiver’s internal memory. It does not send the station or antenna
information. For a static receiver, you will automatically be taken to
the Receiver Session screen to enter your station site ID and send the
antenna information. For a stop and go receiver, you will be
prompted to start your first occupation using the Receiver Session
screen.
Data Collection
1.
With the
GPS Mode
set to
Post Process
, go to the Data Collection
screen from the Survey menu.
2.
Choose if you wish to
Store point in
:
Receiver and job file
or the
Receiver file only
. If you choose to store the point in
Receiver and
job file,
then the site ID must be a unique point name in the
Survey Pro job and you will be prompted to put the point on the
autonomous layer. If you choose to store the point in the
Receiver